fmu

The fmu app configures the FMU board. It controls the multi-function mappings of a number of pins that can be used with different functions.

Update Rate

If FMU is configured for PWM outputs, the update rate can be set with the pwm -u parameter:

fmu mode_pwm
pwm -u 400 -m 0xff

Modes

To assign a given port mapping, the app can be called with these parameters:

  • mode_gpio – Configures all six multi function pins as GPIOs
  • mode_serial – Enabled the blue USART2 RX and TX plus the green USART2 RTS and CTS
  • mode_pwm – Enables SRV1-SRV4
  • mode_gpio_serial – Enables the red function mapping for the PX4IOAR board
  • mode_pwm_serial – Enables the blue USART2 RX and TX pins plus SRV2 and SRV3
  • mode_pwm_gpio – Enables SRV1-SRV4 and GPIO_EXT1 and GPIO_EXT2

To set a specific configuration, call fmu like this:

nsh> fmu mode_gpio_serial

Note that the EXP and MULTI connectors share a number of pins. Same names / colors imply the same pin. Pins on the MULTI connector are always ESD protected / level shifted, pins on the EXP connector are mostly on the 3.3V MCU voltage and unprotected.

EXP (Expansion) Connector Multi Port Mappings



MULTI (Multifunction) Connector Multi Port Mappings



Translations of this page:


Quick Links

QR Code: URL of current page